Rubber Custom-made Blade Soft Car Wiper Clean Windshield Wipers
1 * Car Windshield Wiper
Universal U-type hook, suit for most kinds of cars.
Frameless design, significantly reduces drag, noise and wind-force.
Flat aerodynamic blade ensures even pressure to reduce smears.
Easy to install and good elastic extension, which can prolong the
life of the blade.
Applicable for rain & freezing weather.
The procedure for selecting a windshield wiper:
When it comes to the windshield wiper, maybe a lot of car friends
don't think about it.In the car's total, the wiper is a relatively
small part.But according to the international driving safety
survey, the traffic accident rate caused by the aging of the
windshield wipers is about five times higher than usual, according
to the international driving safety survey.In the shower season, if
your rain scraper has any trouble, you should quickly fix it or
There are two kinds of windshield wipers, one is the traditional
intermittent type, which is the most common wiper, which has three
to four segments, which are adjusted by the driver according to the
rain and the condition of sight.The other is the rain - beaded
induction, which is often used in mid - and upper-class models.Good
wipers must be heat resistant, cold resistant, resistant to acid
and alkali, corrosion resistance, can joint the windshield, easing
the burden on the motor, low noise, strong dial water, soft, not
scratch the windshield and other characteristics, can make you
clear view.To ensure your driving safety, the maintenance staff
recommends that the windshield wipers be replaced every year.
1. First, find out what kind of rain scraper your car is using,
refer to the manual of the car, and see the model of the rain
2. Pay attention to whether the support rod is connected to the
wiper rocker arm.Some of the arms are screwed to the rocker arm,
while others are locked and locked.
3. Pull up the wiper and use your fingers to touch the rubber
wipers after cleaning to check for damage and the elasticity of the
rubber blades.If the blade is aged, hardened and cracked, the wiper
is not qualified.
4. In the test, the wiper switch is placed at various speed
locations to check whether the wiper is maintained at different
speeds.In particular, it is important to keep an eye on whether the
wipers maintain a certain speed during the movement.
Check the state of the wiper and whether there is any unevenness or
leakage of the wiper.If the following three situations occur, this
is not acceptable.One is the undoing of the pendulum, the wiper of
the wiper;The second is that the contact surface of the rubber can
not be fully fitted to the glass surface, and the cleaning residue
is produced.Third, the glass surface is the water film state after
wiping, the glass produces fine lines, fog and linear residues.
6. Attention should be paid to the abnormal noise of the motor
during the test, especially if the motor "buzz" of the wiper is not
rotating.This means that the wiper mechanical transmission parts
are rusty or stuck, and the wiper switch should be turned off
immediately in case of burning the motor.
7. Some people think that the longer the brush length, the bigger
the area of the brush, the better the view.In fact, the wiper blade
is not as long as possible.Lengthening the length of the windshield
wiper can increase the visibility range, but it will also increase
the burden of the windshield motor and the rain scraper.Of course,
it's ok to lengthen, but make sure that you don't get in the way of
Wiper is also known as wiper, water washing, windscreen wiper,
wiper blade, or brush is used to shave their attached to the
vehicle windshield rain and dust equipment, to improve the
visibility of the driver, to increase driving safety.Because of the
law, almost everywhere cars have wipers.The rear Windows of the
hatchback and suvs are also equipped with windshield wipers.In
addition to cars, other means of transport are also equipped with
wipers, such as trains and trams.Some engineering equipment, such
as cranes, also equipped with wipers.
|Name: Car Wiper||Material: Rubber|
|Color: Black||Term of Trade: EXW(Guangzhou)|
|Brand: JR||Place of China: Guangzhou,China|
1. Product type: Automobile wiper blade
2. Application: universal
3. Material: 100% natural rubber, Steel
4. Size: 14 inches and 26 inches
5. Wiper arm type: U hook
6. Frame type: Without frame, bracketless
How to install:
1. Take off the original wiper blades.
2. Open the hook of the wiper blade.
3. Fit the wiper blade on the U-type hook.
4. Pull the wiper blade up, make the U-type hook and the wiper
blade connect tightly.
5. Close the hook of the wiper blade.
1.Positive Feedback is very important to us.if you are satisfied
with our service, please remeber to give a positive feedback.
2.Please contact us before leaving neutral or negative feedback,we
will try our best to solve the problems.
3.If you are not satisfied with our best to solve the
problems,please contanct us before leaving your feedback and we
will resolve the issue immediately.thank you very much.
1.We could provide almost all sizes of car Front And Rear wiper blades.
2.If this product is not the one you need, please log into follow
website to search for it.
3.Or please send a message to me with leaving your car model and
car period, I would like to choose suitable wipers for you as soon as possible after receiving it
High quality and Durable